Hyundai Santa Fe (DM): Input Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Input Speed Sensor. Repair procedures

Inspection

1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.

Removal

1.
Remove the valve body assembly.
2.
Disconnect the input & output speed sensor connector(A).
3.
Remove the input & output speed sensor (B) after removing the bolts(2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Installation

1.
Install in the reverse order of removal.
•
Adding coolant.
•
Adding Automatic Transaxle Fluid(ATF).

Input Speed Sensor. Troubleshooting
Signal Waveform ...

Output Speed Sensor. Description and Operation
Description The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM). ...

See also:

Immobilizer Indicator Light (With Smart Key)
This indicator light illuminates for up to 30 seconds: • When the vehicle detects the smart key in the vehicle properly while the Engine Start/Stop Button is ACC or ON. - At this time, you can start ...

Rear Door Window Glass. Repair procedures
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Pull down rear door window glass by pressing the power window glass switch. 4. After loosening the mounting ...

Hood Insulator Pad. Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). • Be careful not to scratch the hood panel. 2. Install in the reverse order of removal. • Replace any damaged ...