Hyundai Santa Fe (DM): Jump starting procedure - Emergency starting - What to do in an emergencyHyundai Santa Fe (DM): Jump starting procedure

✽ NOTICE

If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal injury or damage to both vehicles, adhere strictly to the following procedure.

Детальная информация knoxville granite and marble на сайте.

1.Make sure the booster battery is 12-volt and that its negative terminal is grounded.
2.If the booster battery is in another vehicle, do not allow the vehicles to touch.
3.Turn off all unnecessary electrical loads.
4.Connect the jumper cables in the exact sequence shown in the illustration. First connect one end of a jumper cable to the positive terminal of the discharged battery (1), then connect the other end to the positive terminal on the booster battery (2). Proceed to connect one end of the other jumper cable to the negative terminal of the booster battery (3), then the other end to a solid, stationary, metallic point (for example, the engine lifting bracket) away from the battery (4). Do not connect it to or near any part that moves when the engine is cranked.
Make sure that there is no contact between the bodywork of the two vehicles; otherwise, there is the danger of short circuits.
Do not allow the jumper cables to contact anything except the correct battery terminals or the correct ground. Do not lean over the battery when making connections.

CAUTION - Battery cables

Do not connect the jumper cable from the negative terminal of the booster battery to the negative terminal of the discharged battery. This can cause the discharged battery to overheat and crack, releasing battery acid.

5.Start the engine of the vehicle with the booster battery and let it run at 2,000 rpm, then start the engine of the vehicle with the discharged battery. If the first starting attempt is not successful, wait a few minutes before making another attempt in order to allow the discharged battery to recharge.

To charge the discharged battery enough, it is recommended to let the engine at idle or to drive the vehicle for a certain period of time.

If the cause of your battery discharging is not apparent, you should have your vehicle checked by an authorized HYUNDAI dealer.

Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recommend that ...

Push-starting
Vehicles equipped with automatic transaxle cannot be push-started. Follow the directions in this section for jump-starting. WARNING Never tow a vehicle to start it because the sudden surge forward when ...

See also:

Troubleshooting
Troubleshooting Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode User’s phone is Bluetooth off mode User’s phone ...

Luggage Side Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Battery. Description and Operation
Description 1. The MF(Maintenance Free) battery is, as the name implies, totally maintenance free and has no removable battery cell caps. 2. The MF(Maintenance Free) battery does not require water replenishment ...