Hyundai Santa Fe (DM): Knee Airbag (KAB) Module. Repair procedures
Removal
| 1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 2. |
Remove the crash pad lower panel.
|
| 3. |
After loosening the mounting nuts and then remove the knee airbag
(A).
|
| 4. |
Disconnect the knee airbag harness connector.
|
Installation
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Connect the knee airbag connector.
|
| 4. |
Tighten the knee airbag mounting nuts.
|
| 5. |
Install the crash pad lower panel.
|
| 6. |
Install the crash pad side cover.
|
| 7. |
Reconnect the battery negative cable.
|
| 8. |
After installing the knee airbag, confirm proper system operation:
|
Knee Airbag (KAB) Module. Components and Components Location
Components ...
Airbag Module Disposal. Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags must be ...
See also:
Purge Control Solenoid Valve (PCSV). Description and Operation
Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ECM grounds ...
CVVT & Camshaft. Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...
Fuel Pressure Control Valve. Specifications
Specification Item Specification Coil Resistance (Ω) 0.5 [20°C(68°F) ...
