Hyundai Santa Fe (DM): Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe (DM): Knock Sensor (KS). Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
3.
Disconnect the injector connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS). Schematic Diagrams
Circuit Diagram ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...

See also:

Brake Pedal. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the shower duct (A). 4. Disconnect the stop lamp switch connector (A). ...

Balance Shaft & Oil Pump. Components and Components Location
Components 1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft chain guide 6. Balance shaft chain tensioner ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...