Hyundai Santa Fe (DM): Ladder Frame. Repair procedures
Removal
|
|
In case of removing the high pressure fuel pump,
high pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure fuel. So don’t do any repair
work right after engine stops.
|
1. |
Remove the engine assembly from the vehicle.
|
2. |
Disconnect the transaxle assembly from engine assembly.
|
3. |
Install the engine to an engine stand for disassembly.
|
4. |
Remove the intake manifold.
|
5. |
Remove the exhaust manifold.
|
6. |
Remove the timing chain.
|
7. |
Remove the cylinder head assembly.
|
8. |
Remove the drive plate and the adapter plate.
|
9. |
Remove the balance shaft & oil pump assembly.
|
10. |
Remove the A/C compressor.
|
11. |
Remove the alternator.
|
12. |
Remove the water pump assembly.
|
13. |
Remove the tensioner assembly integrated bracket
(A).
|
14. |
Remove the oil level gauge tube (A).
|
15. |
Remove the knock sensor (A).
|
16. |
Remove the oil pressure sensor (A).
|
17. |
Remove the cover (B) and the CKPS (Crankshaft position
sensor) (A).
|
18. |
Remove the balance shaft module.
|
19. |
Remove the ladder frame (A).
|
Installation
1. |
Apply liquid gasket to the mating surface of cylinder
block and ladder frame.
|
2. |
Install ladder frame(A) with 10 bolts, in several
passes, in sequence shown.
|
3. |
Install the other parts in reverse order of removal.
|
Rear Oil Seal. Repair procedures
Removal 1. Remove the automatic transaxle. 2. Remove the drive plate. 3. Rmove the rear oil sela(A). Installation 1. Install rear oil seal. (1) Apply engine oil to a new oil seal lip. (2) Using SST(09231-H1100, ...Repair procedures
Disassembly • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid ...See also:
Changing the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. CALIFORNIA PROPOSITION 65 WARNING Engine oil contains chemicals ...
Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...
Repair procedures
Inspection [Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied. ECM displays ...