Hyundai Santa Fe: Lubrication System
Intake Air Temperature Sensor (IATS). Repair procedures 26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures Rear Wiper Motor. Repair procedures
Troubleshooting Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole of the water pump Visually check • Check leaks after about ten-minute warming up. • If coolant still leaks, replace ...
Water pump. Troubleshooting
Oil and filter replacement • Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. In addition, used ...
Engine Oil. Repair procedures - RevisedSee also:
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within the specification. Specification: ...
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor operates ...
