Hyundai Santa Fe (DM): Luggage Room Lamp. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the luggage room lamp lens (A) with a flat-tip
screwdriver after loosening the screws (2EA).
|
| 3. |
Remove the luggage room lamp bulb (A).
|
| 4. |
Remove the luggage room lamp assembly (A) after disconnecting
the connector.
|
| 5. |
If it is necessary to replace the bulb, replace the
luggage room lamp bulb.
|
Installation
| 1. |
Install the luggage room lamp assembly after connecting
the lamp connector.
|
High Mounted Stop Lamp. Repair procedures
Removal High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the rear spoiler. 3. Remove the high mounted stop lamp assembly (A) after loosening screws (4EA). Installation ...
Rear Combination Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the screws (2EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp (B). ...
See also:
Heated Oxygen Sensor (HO2S). Specifications
Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.5 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) Output Voltage(V) RICH Approx. 0.9 LEAN Approx. 0.04 ...
Door locks
Operating door locks from outside the vehicle Mechanical key [A] : Unlock, [B] : Lock First, pull the outside door handle (1) and push the hook (2) located inside of outside door handle by using the mechanical ...
Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal ...
