Replacement
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the third row seat.
|
2. |
Remove the rear door scuff trim.
|
3. |
Remove the rear transverse trim.
|
4. |
Push the second row seat towards the front of the vehicle as far
as possible.
|
5. |
Slighty remove the rear door body side weatherstrip.
|
6. |
Slighty remove the tail gate weatherstrip.
|
7. |
Remove the second row seat belt lower anchor cover (A).
|
8. |
After loosening the mounting bolt, then remove the second row
seat belt lower anchor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
|
|
9. |
After loosening the mounting bolt, then remove the third row seat
belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
|
|
10. |
After loosening the mounting screws, then remove the luggage side
trim (A).
|
11. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
Component Location 1. Luggage side trim ...
Component Location 1. Rear pillar trim ...
See also:
Schematic Diagrams
Circuit Diagram ...
Oil Level Gauge & Pipe. Repair procedures
Removal and Installation 1. Remove the oil gauge(A). 2. Remove the intake manofold. 3. Remove the oil level pipe(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Install in ...
Important Safety Notice
Important Safety Notice Proper service methods and repair procedures are essential for safe, reliable operation of all motor vehicles as well as personal safety of the operator. The service procedures ...