Hyundai Santa Fe (DM): Manifold Absolute Pressure Sensor (MAPS). Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor
and is installed on the surge tank. It senses absolute pressure of the surge
tank and transfers the analog signal proportional to the pressure to the ECM.
By using this signal, the ECM calculates the intake air quantity and engine
speed.
The MAPS consists of a piezo-electric element and a hybrid IC amplifying
the element output signal. The element is silicon diaphragm type and adapts
pressure sensitive variable resistor effect of semi-conductor. Because 100%
vacuum and the manifold pressure apply to both sides of the sensor respectively,
this sensor can output analog signal by using the silicon variation proportional
to pressure change.
ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...
Manifold Absolute Pressure Sensor (MAPS). Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 101.3 (1.03, 14.7) 4.0 ...
See also:
Output Speed Sensor. Schematic Diagrams
Circuit Diagram ...
Front Door Window Glass. Repair procedures
Replacement 1. Remove the front door trim. 2. Remove the front door belt inside weatherstrip (A). 3. Remove the front door window glass mounting hole plug (B). • Be careful not to drop the glass and/or ...
Fuel Filler Door Open Switch. Repair
procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...
