Hyundai Santa Fe (DM): Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.
1. Start the engine.
2. Set the mode to the desired position. For improving the effectiveness of heating
and cooling;
- Heating:
- Cooling:
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
- Mode selection
- Temperature control
- Air intake control
- Fan speed control
- Air conditioning
- OFF mode
- Climate information screen selection
Automatic heating and air conditioning
1. Press the AUTO button. The modes, fan speeds, air intake and air-conditioning will be controlled automatically according to the temperature setting. 2. Set the driver’s temperature control switch ...Mode selection
The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “Manual climate control ...See also:
Engine Room Under Cover. Components and
Components Location
Components 1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH) ...
Canister Close Valve (CCV). Schematic Diagrams
Circuit Diagram ...
Propeller Shaft. Repair procedures
Removal 1. After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A). Tightening torque: 49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft) 2. Remove ...