Hyundai Santa Fe (DM): Multi fuse
If the multi fuse is blown, it must be removed as follows:
1. Disconnect the negative battery cable.
2. Remove the bolts shown in the picture above.
3. Replace the fuse with a new one of the same rating.
4. Reinstall in the reverse order of removal.
✽ NOTICE
If the multi fuse is blown, consult an Authorized HYUNDAI Dealer.
Engine compartment panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse box cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, ...
Fuse/Relay panel description
Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to your vehicle. ...
See also:
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull off the road and ...
CVVT & Camshaft. Components and Components Location
Components 1. Camshaft bearing cap 2. Camshaft front bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust CVVT assembly 6. Intake CVVT assembly 7. Exhaust camshaft upper bearing 8. Intake camshaft ...
Engine And Transaxle Assembly
Engine Cover. Repair procedures Removal and Installation 1. Remove the engine cover (A). • Remove the engine cover on room temperature. • Do not disengage both front and rear mounting ...
