Hyundai Santa Fe: Oil Pressure Switch. Repair procedures
Inspection
| 1. |
Check the continuity between the terminal and the
body with an ohmmeter.
If there is no continuity, replace the oil pressure
switch.
|
| 2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 50kPa (0.50kgf/cm²,
7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
Balance Shaft & Oil Pump. Repair procedures
Removal 1. Remove the timing chain. 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain hydraulic tensioner (B). 4. Remove the balance shaft ...
Oil Level Gauge & Pipe. Repair procedures
Removal and Installation 1. Remove the oil gauge(A). 2. Remove the intake manofold. 3. Remove the oil level pipe(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Install in ...
See also:
Hood Assembly. Repair procedures
Replacement • Be careful not to damage the hood and body. • When removing and installing the hood, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, ...
Knee Airbag (KAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. 3. After loosening the mounting nuts and then remove the ...
Driver Airbag (DAB) Module and Clock Spring. Components and Components Location
Components 1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...
