Hyundai Santa Fe (DM): Output Speed Sensor. Description and Operation - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe (DM): Output Speed Sensor. Description and Operation

Description

The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the Transaxle Control Module(TCM). The sensor provides critical input data that's used in feedback control, damper clutch control, gear setting control, line pressure control, clutch activation pressure control, and sensor fault analysis.


Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...

Output Speed Sensor. Specifications
Specifications ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40~150)) -40~302 Air gap(mm)in. (0.25~0.70) 0.0098~0.0276 Output voltage (V) High 1.18~1.68 Low 0.59~0.84 ...

See also:

Maintenance under severe usage conditions
The following items must be serviced more frequently on cars normally used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals. R : Replace I : Inspect and, ...

ICM (Integrated Circuit Module) Relay Box. Description and Operation
Description The ICM relay is united with (rear blower motor, cornering lamp, rear fog lamp, two turn unlock, burglar alram relay) which installed inside the lower crash pad. ...

Repair procedures
Removal 1. Remove the front bumper cover. 2. Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B). [Disk type] [Shell type] Installation 1. Install ...