Hyundai Santa Fe (DM): Outside lamp - Rear combination lamp bulb replacement - Light bulbs - MaintenanceHyundai Santa Fe (DM): Outside lamp

1. Open the tailgate.

1. Open the tailgate.
2. Remove the service cover using a flat-blade screwdriver.
3. Loosen the lamp assembly retaining please verify.
4. Remove the rear combination lamp assembly from the body of the vehicle.

5. Remove the socket from the assembly by turning the socket counterclockwise

5. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly.
6. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until the tabs on the bulb align with the slots in the socket. Pull the bulb out of the socket. (Side marker : Remove the bulb from the socket by pulling it out)
7. Insert a new bulb by inserting it into the socket and rotating it until it locks into place.
8. Install the socket in the assembly by aligning the tabs on the socket with the slots in the assembly. Push the socket into the assembly and turn the socket clockwise.
9. Reinstall the lamp assembly to the body of the vehicle.

Rear combination lamp bulb replacement
(1) Rear stop and tail lamp (2) Rear tail lamp (3) Rear turn signal lamp (4) Back-up lamp (5) Rear side marker ...

Inside lamp
1. Open the tailgate. 2. Remove the service cover using a flat-blade screwdriver. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with ...

See also:

Components and Components Location
Component Location (1) 1. Smart key unit 2. Buzzer 3. RF receiver 4. Door outside handle 5. Interior antenna 2 6. Interior antenna 1 Component Location (2) 1. Tailgate open switch 2. Bumper antenna 3. ...

Cruise control switch
CRUISE : Turns cruise control system on or off. CANCEL: Cancels cruise control operation. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. ...

Repair procedures
Replacement [Removal] • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the front pillar trim. 2. Remove the cowl top cover. 3. Using a screwdriver ...