Hyundai Santa Fe (DM): Outside rearview mirror - Mirrors - Features of your vehicleHyundai Santa Fe (DM): Outside rearview mirror

Be sure to adjust mirror angles before driving.

Your vehicle is equipped with both left-hand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch. The mirror heads can be folded back to prevent damage during an automatic car wash or when passing in a narrow street.

CAUTION - Outside rearview mirrors

  • The right outside rearview mirror is convex. Objects seen in the mirror are closer than they appear.
  • Use your interior rearview mirror or direct observation to determine the actual distance of following vehicles when changing lanes.

CAUTION

Do not scrape ice off the mirror face; this may damage the surface of the glass. If ice should restrict movement of the mirror, do not force the mirror for adjustment. To remove ice, use a deicer spray, or a sponge or soft cloth with warm water.

CAUTION

If the mirror is jammed with ice, do not adjust the mirror by force. Use an approved spray de-icer (not radiator antifreeze) to release the frozen mechanism or move the vehicle to a warm place and allow the ice to melt.

WARNING

Do not adjust or fold the outside rearview mirrors while the vehicle is moving.This could result in loss of control, and an accident which could cause death, serious injury or property damage.

Remote control

The electric remote control mirror switch allows you to adjust the position of

The electric remote control mirror switch allows you to adjust the position of the left and right outside rearview mirrors.

To adjust the position of the mirrors:

1. Place the ignition switch in the ON position.
2. Move the lever(1) to R (right) or L (left) to select the right side mirror or the left side mirror.
3. Press a corresponding point on the mirror adjustment control to position the selected mirror up, down, left or right.
4. After the adjustment, position the lever in the center to prevent inadvertent movement.

CAUTION

  • The mirrors stop moving when they reach the maximum adjusting angles, but the motor continues to operate while the switch is pressed. Do not press the switch longer than necessary, the motor may be damaged.
  • Do not attempt to adjust the outside rearview mirror by hand. Doing so may damage OANNCO2076 the mirror.

Folding the outside rearview mirror

To fold outside rearview mirror, grasp the housing of mirror and then fold it

To fold outside rearview mirror, grasp the housing of mirror and then fold it toward the rear of the vehicle.

Programming
To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons ( , ), HomeLinkВ® Channel 1 and Channel 3, until the indicator light begins to flash ...

Instrument cluster
Type A Type B 1. Tachometer 2. Speedometer 3. Engine coolant temperature gauge 4. Fuel gauge 5. LCD display 6.Warning and indicator lights (if equipped) 7. Turn signal indicator lights ❈ The actual ...

See also:

Description and Operation
Description Exhaust emissions (CO, HC, NOx) are controlled by a combination of engine modifications and the addition of special control components. Modifications to the combustion chamber, intake manifold, ...

Child Restraint System (CRS)
Children Always in the Rear WARNING Always properly restrain children in the vehicle. Children of all ages are safer when restrained in the rear seat. A child riding in the front passenger seat can be ...

Output Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...