Hyundai Santa Fe (DM): Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection
1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
|
3. |
Disconnect the solenoid valve connector(A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Schematic Diagrams
Circuit Diagram ...SS-A Solenoid Valve(ON/OFF). Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...See also:
Crach Pad Center Panel. Components and Components Location
Component Location 1. Crash pad center lower panel ...
Front Seat Belt Buckle. Repair procedures
Replacement 1. Remove the front seat assembly. 2. Disconnect the front seat belt buckle connector wiring (A). 3. After loosening the mounting nut, then remove the front seat belt buckle (A). Tightening ...
Repair procedures
Operation and Leakage Check Check all of the following items: Component Procedure Brake Booster (A) Check brake operation by applying the brakes during a test drive. If the brakes do not work properly, ...