Hyundai Santa Fe (DM): Parking Brake Cable. Repair procedures
Removal
Parking brake pedal Type |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the crash pad lower panel.
|
3. |
Remove the parking brake cable mounting nut (A) and bolts(B).
|
4. |
Remove the parking brake cable adjusting nut(A) and the fixing
clip(B), and then remove the parking brake pedal.
|
5. |
Remove the floor console.
|
6. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
7. |
Raise the vehicle, and make sure it is securely supported.
|
8. |
Remove the rear wheel & tire.
|
9. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
10. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
11. |
Installation is reverse of removal.
|
Parking brak e lever Type
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the floor console.
|
3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
4. |
Raise the vehicle, and make sure it is securely supported.
|
5. |
Remove the rear wheel & tire.
|
6. |
Remove the parking brake cable (B) after removing the fixing clip
(A).
|
7. |
Loosen the parking brake cable bracket bolts and remove the rear
parking brake cable.
|
8. |
Installation is reverse of removal.
|
Parking Brake Pedal Assembly. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the junction box. 4. Disconnect the parking brake switch connector. 5. ...See also:
Rear combination lamp bulb replacement
(1) Rear stop and tail lamp (2) Rear tail lamp (3) Rear turn signal lamp (4) Back-up lamp (5) Rear side marker ...
Schematic Diagrams
Circuit Diagram ...
Specifications
Specifications Item Specification Type Motor Driven Power Steering Steering gear Type Rack & Pinion Rack stroke 160mm Steering angle(Max.) Inner 38.79°±1°30’ Outer 31.92° Tightening Torques Item ...