Hyundai Santa Fe (DM): Power Door Mirror Actuator. Repair
procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the connector (B) after removing the front
door quadrant cover (A).
|
| 3. |
Disconnect the power door mirror connector (A) from
the harness.
|
| 4. |
Apply battery voltage to each terminal as shown in
the table and verify that the mirror operates properly.
[Actuator]
Mirror Heater
Turn Signal Lamp
|
Power Door Mirror Switch. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front left door trim. 3. Remove the power mirror switch (A) from the door trim. Installation 1. Install the power mirror switch. 2. ...
Power Windows
...
See also:
Reprogramming a single HomeLink® button
To program a new device to a previously trained HomeLink® button, follow these steps: 1. Press and hold the desired HomeLink® button. Do NOT release until step 4 has been completed. 2. When the indicator ...
Ignition switch position
LOCK The steering wheel locks to protect against theft. The ignition key can be removed only in the LOCK position. When turning the ignition switch to the LOCK position, push the key inward at the ACC ...
To remove the cargo security screen
1. Push in the guide pin. 2. While pushing the lever, pull out the cargo security screen. 3. Open the luggage tray and keep the cargo security screen in the tray. ...
