Hyundai Santa Fe (DM): Power Seat Control Switch. Repair procedures
Inspection
Power Seat Control Switch |
1. |
With the power seat switch in each position, make
sure that continuity exists between the terminals below. If continuity
is not as specified, replace the power seat switch.
|
Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front seat shield outer cover.
|
3. |
Remove the power seat control switch (A) and lumbar
support switch (B).
|
Installation
1. |
Install the power seat control switch after connecting
the connector.
|
Power Seat Control Switch. Schematic Diagrams
Circuit Diagram ...See also:
Roller Blind Motor. Repair procedures
Replacement 1. Refer to the inspection procedure in the panorama sunroof motor. ...
Tail Gate Back Panel. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Antenna. Repair procedures
Inspection Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. 3. Check for continuity between the outer poles of ...