Hyundai Santa Fe (DM): Power Seat Motor. Repair procedures
Inspection
1. |
Disconnect the connectors for each motor.
A : Slide motor
B : Front height motor
C : Rear height motor
D : Lumbar support motor (Horizontal)
E : Lumbar support motor (Vertical)
F : Recline motor
|
2. |
With the battery connected directly to the motor
terminals, check if the motors run smoothly.
|
3. |
Reverse the connections and check that the motor
turns in reverse.
|
4. |
If there is an abnormality, replace the motors.
[Driver]
[Passenger]
|
Components and Components Location
Component Location 1. Slide motor 2. Front height motor 3. Rear height motor 4. Lumbar support motor (Horizontal) 5. Lumbar support motor (Vertical) 6. Reclining motor 7. Power seat switch 8. Reclining ...Power Seat Control Switch. Schematic Diagrams
Circuit Diagram ...See also:
Oil Level Gauge & Pipe. Repair procedures
Removal and Installation 1. Remove the oil gauge(A). 2. Remove the intake manofold. 3. Remove the oil level pipe(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Install in ...
Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. 3. Remove the steering column upper and lower shrouds (A) after removing 3 screws. 4. Disconnect the light switch ...
Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used to identify ...