Hyundai Santa Fe (DM): Power Window Motor. Repair procedures
Inspection
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
|
3. |
Disconnect the connector (A) from the motor.
(A : Safety, B : Standard)
|
4. |
Connect the motor terminals directly to battery voltage
(12V) and check that the motor operates smoothly. Next, reverse the
polarity and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
5. |
Connect the terminal No. 2 and No. 3 to battery voltage
(12V) and check that the motor operates smoothly when connecting the
terminals below.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim.
|
3. |
Disconnect the connector (A) from the motor.
|
4. |
Connect the motor terminals directly to battery voltage
(12V) and check that the motor operates smoothly. Next, reverse the
polarity and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Power Window Motor. Schematic Diagrams
Circuit Diagram ...Power Window Switch. Components and Components Location
Components Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...See also:
Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...
Front Oil Seal. Repair procedures
Removal and Installation 1. Remove the crankshaft damper pulley. 2. Remove the front oil seal(A). 3. Install the crankshaft front oil seal (A) using SST (09214-3K000, 09231-H1100) (B). ...
Variable Intake Solenoid (VIS) Valve. Description and Operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens ...