Hyundai Santa Fe (DM): Power Window Switch. Repair procedures
Diagnosis With GDS
| 1. |
The BCM can be diagnosed by using the GDS. The BCM
communicates with the GDS which then displays inputs and outputs along
with codes.
It will be able to diagnose defects of power door
lock/unlock with GDS quickly. GDS can operates actuator forcefully,
input/output value monitoring and self diagnosis.
|
| 2. |
To diagnose the SJB function, select the vehicle
model, BCM and DDM/ADM.
|
| 3. |
Select "Input/output monitoring", if you will check
current data of power door lock system. It provides input/output status
of DDM/ADM.
|
| 4. |
To perform functional test on SJB outputs, select
"Actuation Test".
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
|
| 3. |
Remove the power window bezzel assembl (A) after
loosening the mounting screws (12EA).
|
| 4. |
Remove the power window switch assembly (A) after
loosening the mounting screws (6EA).
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
|
| 3. |
Remove the power window switch assembly (A) after
loosening the mounting screws (5EA).
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim.
|
| 3. |
Remove the power window switch assembly (A) after
loosening the mounting screws (3EA).
|
| 4. |
Check for continuity between the terminals in each
switch position according to the table. If the continuity condition
is not normal, replace the switch.
|
Installation
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the front door trim after connect the connector.
|
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the front door trim after connect the connector.
|
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the rear door trim after connect the connector.
|
Power Window Switch. Schematic Diagrams
Circuit Diagram Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...
See also:
High mounted stop lamp replacement
1.Open the tailgate. 2.Gently remove the center cover of the rear tailgate trim. 3.Disconnect the electrical connector. 4.Loosen the retaining nuts and remove the spoiler. 5.Remove the high mounted stop ...
Valve Body. Description and Operation
Description The valve body is essential to automatic transaxle control and consists of various valves used to control the oil feed from the oil pump. Specifically, these valves consist of pressure regulator ...
General Tightening Torque Table
General Tightening Torque Table Bolt nominal diameter (mm) Pitch (mm) Torque Nm (kg.cm, lb.ft) Head Mark 4 Head Mark 7 M5 0.8 3 ~ 4 (30 ~ 40, 2.2 ~ 2.9) 5 ~ 6 (50 ~ 60, 3.6 ~ 4.3) M6 1.0 5 ~ 6 (50 ~ 50, ...
