Hyundai Santa Fe (DM): Propeller Shaft. Repair procedures - Propeller Shaft Assembly - Driveshaft and axleHyundai Santa Fe (DM): Propeller Shaft. Repair procedures

Removal

1.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

3.
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts (A).
Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)
Do not reuse bolts.

4.
Install in the reverse order of removal.
•
When assembl ying propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.

Propeller Shaft. Components and Components Location
Components 1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Differential Carrier Assembly
...

See also:

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...

Specifications
Specifications Tightening Torques Items N.m Kgf.m lb-ft Transfer assembly mounting bolts 60.8~65.7 6.2~6.7 44.8~48.5 4WD ECM mounting nuts 9.8~11.8 1.0~1.2 7.2~8.7 Coupling assembly mounting bolts 56.9~64.7 ...

Seat Heater (Air Ventilation). Components and Components Location
Components ...