Hyundai Santa Fe (DM): Purge Control Solenoid Valve (PCSV). Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the PCSV connector.
|
3. |
Measure resistance between the PCSV terminals 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the purge control solenoid valve connector (A).
|
3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
4. |
Remove the valve from the bracket (C) in the direction of the
arrow.
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Purge Control Solenoid Valve (PCSV). Schematic Diagrams
Circuit Diagram ...CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...See also:
Sunroof open warning
If the driver removes the ignition key (smart key: turns off the engine) and opens the driver-side door when the sunroof is not fully closed, the warning chime will sound for a few seconds and a message ...
Rear Spoiler. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Rear seat folding from outside
Pull the rear seat back folding lever out. The rear seat back will be folded. If you pull the left side lever (1) out, left side seat back and center seat back will be folded. If you pull the right side ...