Hyundai Santa Fe (DM): Rail Pressure Sensor (RPS). Description and Operation - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe (DM): Rail Pressure Sensor (RPS). Description and Operation

Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Description and Operation

Description

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.


Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 ...

Rail Pressure Sensor (RPS). Specifications
Specification ...

See also:

Canister Close Valve (CCV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specification. Specification: ...

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 5° TPS TPS 1 fault ECM looks at TPS2 TPS 2 fault ECM looks at TPS1 TPS 1,2 fault Throttle valve stuck at 5° APS APS 1 fault ECM looks at ...

Components and Components Location
Components [M/T] 1. Front console garnish [LH] 2. Front console garnish [RH] 3. Console upper cover 4. Ash tray 5. Console rear complete assembly 6. Console front complete assembly 7. Console side cover ...