Hyundai Santa Fe (DM): Rear Alignment. Repair procedures
Rear wheel alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always position the vehicle
on a level surface.
Prior to inspection, make sure that the rear suspension system
is in normal operating condition and that the tires are inflated to
the specified pressure.
|
B - A. 0: Toe in (+)
B - A < 0: Toe out (-)
|
1. |
Loosen the nut holding the assist arm cam bolt (A).
|
2. |
Adjust rear toe by turning the rear assist arm cam bolt (A) clockwise
or counter clockwise. Toe adjustment should be made by turning the right
and left cam bolt by the same amount.
|
3. |
When completing the toe adjustment, tighten the nut to specified
torque.
|
Camber : -1° ± 0.5°
|
Components and Components Location
Components 2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm 4WD 1. Rear assist arm 2. Rear cross member 3. Rear ...Rear Shock Absorber. Repair procedures
Removal 2WD 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...See also:
Description and Operation
Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an ...
Luggage Room Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver after loosening the screws (2EA). 3. Remove the luggage room lamp bulb (A). ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
Description Underdrive brake control solenoid valve(UD/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the underdrive brake. ...