Hyundai Santa Fe (DM): Rear Bumper beam Assembly. Repair procedures - Rear Bumper - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Bumper beam Assembly. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
2.
Disconnect the rear bumper beam mounting wiring harness (A).
3.
After loosening the mounting screws and clips, then remove the rear bumper beam assembly (B).
4.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Rear Bumper beam Assembly. Components and Components Location
Component Location 1. Rear bumper beam assembly ...

Front Seat
...

See also:

Luggage Side Trim. Components and Components Location
Component Location 1. Luggage side trim ...

Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward, unsnap it from the bracket (1) and ...

ATF Warmer. Repair procedures
Removal 1. Drain the coolant. 2. Remove the air cleaner assembly and air duct. 3. Remove the battery and battery tray. 4. Remove the under cover(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, ...