Hyundai Santa Fe (DM): Rear Bumper Cover. Repair procedures
Replacement
|
|
1. |
After loosening the mounting screws, then remove the rear combination
lamp (A).
|
2. |
Disconnect the rear combination lamp connector (A).
|
3. |
Loosen the rear bumper lower mounting clips.
|
4. |
Loosen the mounting bolts.
|
5. |
Disconnect the rear bumper main connector (A).
|
6. |
After loosening the rear bumper side's mounting screws, then disconnect
the side's.
|
7. |
Loosen the rear bumper upper mounting clip.
|
8. |
Remove the rear bumper cover (A).
|
9. |
Install in the reverse order of removal.
|
Rear Bumper Cover. Components and Components Location
Component Location 1. Rear bumper cover ...Rear Bumper beam Assembly. Components and Components Location
Component Location 1. Rear bumper beam assembly ...See also:
Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 ...
Basic Service Symbols
Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning Do not reuse the part. Replace ...
Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...