Hyundai Santa Fe (DM): Rear Console Cover. Repair procedures - Floor Console - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Console Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the rear console cover (A).
2.
Disconnect the power outlet connector (A).
3.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Replace any damaged clips.

Rear Console Cover. Components and Components Location
Component Location 1. Rear console cover ...

Console Armrest. Components and Components Location
Component Location 1. Console armrest ...

See also:

Wheel. Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should be checked using ...

Front Wiper Motor. Components and Components Location
Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly 8. Wiper motor connector ...

Emergency Fastening Device (EFD). Description and Operation
Description The Emergency Fastening Device (EFD) operates as well as the belt pretensioner at the same time, if it gets into its deploy condition after a collision. It is located near the anchor on the ...