Hyundai Santa Fe (DM): Rear Cross Member. Repair procedures - Rear Suspension System - Suspension SystemHyundai Santa Fe (DM): Rear Cross Member. Repair procedures

Replacement

1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire (A).
2.
Remove the parking brake cable.
3.
Loosen the bolt and then remove the trailing arm (A).
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Loosen the shock absorber mounting bolts (A).
Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)

5.
Remove the rear muffler.
6.
Loosen the bolt and then remove the propellar shaft (A).
7.
Loosen the mounting bolts and then remove the rear cross member (A) with the frame.
Tightening torque :
156.9 ~ 176.5N.m (16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)

8.
Remove the rear lower arm.
9.
Remove the rear shock absorber.
10.
Remove the rear upper arm.
11.
Remove the trailing arm.
12.
Remove the rear assist arm.
13.
Remove the drive shaft.
14.
Remove the differential carrier.
15.
Installation is the reverse of removal.

Rear Stabilizer Bar. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Tires/Wheels
...

See also:

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows: 1.Turn the ignition switch to the ON position. 2.Close the sunshade and sunroof completely if ...

General Service Information
General Service Information Protection of the Vehicle Always be sure to cover fenders, seats, and floor areas prior to beginning work.    • The support rod must be inserted into the hole near ...

Rear Disc Brake. Repair procedures
Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Loosen the hose eyebolt (B) and caliper mounting bolts (C), then remove the rear ...