Hyundai Santa Fe (DM): Rear Door Latch. Repair procedures
Replacement
| 1. |
Remove the rear door module.
|
| 2. |
Remove the rear door outside handle base (A) by pushing in the
lock pins located in the back.
|
| 3. |
Remove the rear door outside handle base cable (A).
|
| 4. |
Open the rear door outside handle cable cap (A).
|
| 5. |
Remove the rear door outside handle cable (B).
|
| 6. |
Disconnect the rear door latch connector (B).
|
| 7. |
Remove the rear door latch assembly (A) by pulling it.
|
| 8. |
Remove the rear door inside handle cable (A) by pulling it.
|
| 9. |
Install in the reverse order of removal.
|
Rear Door Latch. Components and Components Location
Component Location 1. Rear door latch ...
Rear Door Belt Outside Weatherstrip. Repair procedures
Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A). 3. Install in ...
See also:
To decrease the cruising speed
Follow either of these procedures: Move the lever down (to SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain. Move the lever down (to SET-) ...
Rear Door Side Weatherstrip. Repair procedures
Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the rear door side weatherstrip (A). ...
Special Service Tools
Special Service Tools Tool (Number and Name) IIIustration Use 09561-11001 Steering wheel puller Remove the steering wheel ...
