Hyundai Santa Fe (DM): Rear Door Side Weatherstrip. Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Door Side Weatherstrip. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Side Weatherstrip. Repair procedures

Replacement

1.
Loosen the rear door checker (B) mounting bolt.
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft)
2.
Detach the clips, then remove the rear door side weatherstrip (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Rear Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

Body Side Molding
...

See also:

ATF Warmer. Description and Operation
Description The ATF warmer is mounted on the valve body cover to reduce oil viscosity friction by increasing oil temperature under cold condition, which in turn improves fuel efficiency. It is serial mounted ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
Circuit Diagram ...

Front Impact Sensor (FIS). Repair procedures
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the front airbag ...