Hyundai Santa Fe (DM): Rear Door Window Glass. Repair procedures - Rear Door - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Door Window Glass. Repair procedures

Replacement

1.
Remove the rear door trim.
2.
Remove the rear door belt inside weatherstrip (A).

3.
Pull down rear door window glass by pressing the power window glass switch.
4.
After loosening the mounting screws, then remove the rear door belt outside weatherstrip (A).

5.
Completely loosen the rear door channel mounting bolts and loosen the nuts as much as you can without the nuts removed from the rear door panel.
6.
Slightly push the rear door channel like the direction of the arrow in the picture below.

Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

7.
Remove the rear door window glass mounting hole plug (B).

•
Be careful not to drop the glass and/or scratch the glass surface.
•
Use the door switch to align the mounting hole/bolt with the hole in the door.
•
If unable to operate the window motor, remove the motor and align the hole by hand.
8.
Carefully adjust the rear door window glass (A) until you can see the bolt, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

9.
Install in the reverse order of removal.
•
Roll the glass up and down to see if it moves freely without binding.
•
Adjust glass position as needed.
•
Make sure the door lock and opens properly.
•
Replace any damaged clips.

Rear Door Window Glass. Components and Components Location
Component Location 1. Rear door window glass ...

Rear Door Module. Components and Components Location
Component Location 1. Rear door module ...

See also:

Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures recommended ...

Sunglass holder
To open the sunglass holder, press the cover and the holder will slowly open. Place your sunglasses in the compartment door with the lenses facing out. Push to close. WARNING Do not keep objects except ...

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. 3. Disconnect the body control module connectors (A). 4. Remove the body control module (A) after loosening ...