Hyundai Santa Fe (DM): Rear Driveshaft Assembly
Power Door Mirror Switch. Repair
procedures ALL Wheel Drive (AWD) transfer mode selection Rear Door Belt Inside Weatherstrip. Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...
Rear Hub - Carrier. Repair procedures
Components 1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot 10. Snap ring 11. Circlip 12. ...
Rear Driveshaft. Components and Components LocationSee also:
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front left door trim. 3. Remove the power mirror switch (A) from the door trim. Installation 1. Install the power mirror switch. 2. ...
✽ NOTICE When driving on normal roads, deactivate the AWD LOCK mode by pushing the AWD LOCK button (the indicator light goes off). Driving on normal roads with AWD LOCK mode(especially, when cornering) ...
Replacement 1. Remove the rear door trim. 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...
