Hyundai Santa Fe (DM): Rear Lower Arm. Repair procedures
Removal
1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Support the rear lower arm (A) with a jack as shown in the illustration.
|
3. |
Loosen the bolt & nut and then remove the rear lower arm (A) with
the rear axle.
|
4. |
Loosen the bolt & nut and then remove the rear lower arm (B) with
the sub frame (A).
|
5. |
Installation is the reverse of removal.
|
6. |
Check the rear alignment.
|
Inspection
1. |
Check the bushing for wear and deterioration.
|
2. |
Check the rear lower arm for deformation.
|
Rear Upper Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...See also:
Troubleshooting
Troubleshooting Symptom Possible cause Remedy Speedometer does not operate Cluster fuse (10A) blown Check for short and replace fuse Speedometer faulty Check speedometer CAN line faulty Check the EMS Wiring ...
Seat belt - Driver's 3-point system with emergency locking retractor
To fasten your seat belt: To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the ...
ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...