Hyundai Santa Fe (DM): Rear Oil Seal. Repair procedures - Cylinder Block - Engine Mechanical SystemHyundai Santa Fe (DM): Rear Oil Seal. Repair procedures

Removal

1.
Remove the automatic transaxle.
2.
Remove the drive plate.
3.
Rmove the rear oil sela(A).


Installation

1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09231-H1100, 09214-3K100) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.
2.
Install the drive plate.
3.
Install the automatic transaxle.

Drive Plate. Repair procedures
Removal and Installation 1. Remove the automatic transaxle . 2. Remove the drive plate (A) and the adapter plate (B). Tightening torque : 117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft) • Always ...

Ladder Frame. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid ...

See also:

ATF Warmer. Description and Operation
Description The ATF warmer is mounted on the valve body cover to reduce oil viscosity friction by increasing oil temperature under cold condition, which in turn improves fuel efficiency. It is serial mounted ...

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. 3. Disconnect the body control module connectors (A). 4. Remove the body control module (A) after loosening ...

Description and Operation
Description Mobile Telemetics System (MTS) Hyundai motor companies are now faced with the task of shifting their paradigm from vehicle-centered services to customer valuecentered services, with the ultimate ...