Hyundai Santa Fe (DM): Rear Seat Assembly. Repair procedures - Rear Seat - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Seat Assembly. Repair procedures

Replacement

[Second row seat assembly]
1.
Push the second row seat assembly [RH] (A) towards the front of the vehicle as far as possible.
2.
Loosen the second center seat belt buckle mounting bolt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Push the second row seat assembly towards the front of the vehicle as far as possible.
4.
Loosen the second row seat assembly rear mounting bolts (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)
[LH]

[RH]
5.
Push the second row seat assembly towards the rear of the vehicle as far as possible.
6.
After loosening the mounting bolts, then remove the second row seat assembly (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

7.
Install in the reverse order of removal.
[Third row seat assembly]
1.
Remove the luggage covering met (A).
2.
After loosening the mounting screws, then remove the luggage floor box (A).
3.
Loosen the third row seat assembly rear mounting bolts (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

4.
Remove the third row seat track mounting cover (A).
5.
After loosening the mounting bolts, then remove the third row seat assembly (A).
Tightening torque :
16.7 ~ 25.5N.m (1.7 ~ 2.6kgf.m, 12.3~18.8lb-ft)

6.
Install in the reverse order of removal.

Rear Seat Assembly. Components and Components Location
Component Location [Second row seat assembly] 1. Second row seat assembly [LH] 2. Second row seat assembly [RH] [Third row seat assembly] 1. Third row seat assembly [LH] 2. Third row seat assembly [RH] ...

Rear Seat Back Cover. Components and Components Location
Component Location [Second row seat assembly] 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] [Third row seat assembly] 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] ...

See also:

Windshield Wiper-Washer Switch. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after loosening 3 screws. 3. Disconnect the connector (A). 4. If necessary of removing ...

Seat Heater Switch. Repair procedures
Removal Driver/ Passenger 1. Disconnect the negative (-) batttery terminal. 2. Remove the floor console assembly. 3. Remove the heater switch after loosening the screws. [A/T] 4. Remove the front tray ...

Theft-alarm system
This system is designed to provide protection from unauthorized entry into the vehicle. This system is operated in three stages: the first is the "Armed" stage, the second is the "Theft-alarm" ...