Replacement
[Second row seat assembly]
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the second row seat assembly [LH].
|
|
2. |
Holding the bottom (B) lift up the rear seat back panel (A) to
the direction of the arrow.
|
|
3. |
Disconnect the rear seat folding cable (A).
|
|
4. |
After loosening the mounting screws, then remove the rear seat
folding cover (A).
|
|
5. |
Install in the reverse order of removal.
|
• |
Replace any damaged clips.
|
|
|
[Third row seat assembly]
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the rear seat back cover.
|
|
2. |
After loosening the mounting screws, then remove the rear seat
latch cover (A).
|
|
3. |
Disconnect the rear seat latch cable (A).
|
|
4. |
After loosening the mounting bolts (A), then remove the rear seat
latch (B).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
|
|
|
5. |
Install in the reverse order of removal.
|
• |
Replace any damaged clips.
|
|
|
Component Location [Second row seat assembly] 1. Rear seat latch [Third row seat assembly] 1. Rear seat latch ...
Component Location [Second row seat assembly] (LH) 1. Rear seat back frame assembly 2. Rear seat cushion frame assembly (RH) 1. Rear seat back frame assembly 2. Rear seat cushion frame assembly [Third ...
See also:
Rear seat folding from outside
Pull the rear seat back folding lever out. The rear seat back will be folded. If you pull the left side lever (1) out, left side seat back and center seat back will be folded. If you pull the right side ...
Shift Cable. Components and Components Location
Components 1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...
High Beam Indicator Light
This indicator light illuminates: When the headlights are on and in the high beam position When the turn signal lever is pulled into the Flash-to-Pass position. ...
Hyundai Santa Fe (DM): Rear Seat Latch. Repair procedures
Rear Seat Latch. Components and Components Location
Rear Seat Frame Assembly. Components and Components Location