Hyundai Santa Fe (DM): Rear Spoiler. Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Santa Fe (DM): Rear Spoiler. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the tail gate upper trim.
2.
Disconnect the washer nozzle (A) and high mounted stop lamp connector (B).
3.
Loosen the rear spoiler mounting nuts (A).
Tightening torque :
5.9 ~ 6.4 N.m (0.6 ~ 0.65 kgf.m, 4.3 ~ 4.7 lb-ft)

4.
Remove the rear spoiler (A).
5.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Replace any damaged clips.

Delta Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Fender Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

See also:

Variable Intake Solenoid (VIS) Valve. Description and Operation
Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ECM opens ...

Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals ...

General Information. Repair procedures
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the engine to warm up ...