Hyundai Santa Fe (DM): Rear Stabilizer Bar. Repair procedures
Removal
1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
In the case of 4WD vehicle, remove the rear differential assembly.
|
3. |
Loosen the nut (A-1ea) and then remove the rear stabilizer link
(B).
[2WD]
[4WD]
|
4. |
Loosen the bolt and then remove the rear stabilizer bar (A) with
the sub frame.
[2WD]
[4WD]
|
5. |
Installation is the reverse of removal.
|
Inspection
1. |
Check the rear stabilizer bar for deformation.
|
2. |
Check the rear stabilizer link ball joint for damage.
|
Rear Assist Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...Rear Cross Member. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage to the hub bolts when removing the front wheel & tire ...See also:
Components and Components Location
Component Location 1. Fuel filler door open switch 2. Fuel filler door release actuator ...
Engine Cover. Repair procedures
Removal and Installation 1. Remove the engine cover (A). 2. Install in the reverse order of removal. ...
Schematic Diagrams
Schematic Diagrams MDPS Circuit Diagram Harness Connector Connector Pin no Pin name Battery 1 Battery + 2 Battery - Vehicle signal 1 Igntion 2 - 3 - 4 - 5 - 6 - 7 CAN_High 8 CAN_Low ...