Hyundai Santa Fe (DM): Rear Upper Arm. Repair procedures - Rear Suspension System - Suspension SystemHyundai Santa Fe (DM): Rear Upper Arm. Repair procedures

Removal

1.
Remove the rear wheel and tire (A) from rear hub .

Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Support the rear lower arm (A) with a jack as shown in the illustration.
Certainly install Jack as being danger because of the tension.

3.
Loosen the bolt & nut and then remove the rear upper arm (A).

Tightening torque :
2WD
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)
4WD
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

[2WD]

[4WD]

4.
Installation is the reverse of removal.
5.
Check the rear alignment.

Inspection

1.
Check the bushing for wear and deterioration.
2.
Check the rear upper arm or damage and deformation.
3.
Check for all bolts and nut.

Rear Shock Absorber. Repair procedures
Removal 2WD 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Rear Lower Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

See also:

Gasoline containing alcohol and methanol
Gasohol, a mixture of gasoline and ethanol (also known as grain alcohol), and gasoline or gasohol containing methanol (also known as wood alcohol) are being marketed along with or instead of leaded or ...

Driving at night
Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may be more difficult ...

Parking Brake Pedal Assembly. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the junction box. 4. Disconnect the parking brake switch connector. 5. ...