Hyundai Santa Fe (DM): Rear Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Santa Fe (DM): Rear Wheel Speed Sensor. Repair procedures

Removal

4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the rear wheel guard.
4.
Disconnect the rear wheel speed sensor connector (A).
5.
Installation is the reverse of removal.
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1).
When inserting the sensor, take care the O-ring not to be damaged.
2WD only
1.
Remove the connector (A) after removing the front wheel speed sensor clip.
2.
Remove the rear wheel speed sensor.
3.
Installation is the reverse of removal.

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Yaw-rate and G Sensor. Description and Operation
Description The yaw rate and G sensor is included inside the air bag control module (SRSCM). When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly ...

See also:

Rear Wiper Motor. Repair procedures
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor operates ...

Flex steer
The FLEX STEER controls steering effort as driver's preference or road condition. You can select the desired steering mode by pressing the FLEX STEER button. Type A Type B When the steering mode button ...

Seat Heater (Non-Air Ventilation). Schematic Diagrams
Circuit Diagram ...