Hyundai Santa Fe (DM): Rear Wiper Motor. Repair procedures - Rear Wiper/Washer - Body Electrical SystemHyundai Santa Fe (DM): Rear Wiper Motor. Repair procedures

Inspection

Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No.
Description
1
Ground
2
Rear wiper motor (+)
3
Parking

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
3.
Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead to terminal 1.
4.
Check that the motor stops running at the off position.


Removal

1.
Detach the rear wiper cap (A).

2.
Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B).

3.
Remove the rear wiper cap & pad (A).

4.
Remove the cover (B) after loosening a rear wiper nut (A).

5.
Remove the tailgate trim after opening the tailgate.
6.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts (2EA).


Installation

1.
Install the rear wiper motor assembly.

Tightening torque Nut :
6.9~9.8 Nm (0.7~1.0 kgf.m, 5.0~7.2 lbf.ft)

2.
Install the tailgate trim.
3.
Install the rear wiper arm and rear wiper cap.

Tightening torque Nut (B) :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.0~8.0 lbf.ft)

4.
Install the rear wiper arm cap after tighting the nut.

Tightening torque Bolt :
13.7~16.7 N.m (1.4~1.7 kgf.m, 10.1~12.3 lbf.ft)

5.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.


Components and Components Location
Component Location 1. Rear wiper arm & blade 2. Tailgate glass hole 3. Grommet 4. Rear wiper arm nut 5. Rear wiper motor assembly 6. Head cap 7. Rear wiper motor bolt ...

Rear Washer Switch. Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Washer Switch ...

See also:

Special Service Tools
Special Service Tools Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture(Beam) Removal and installation of the transaxle. Except lower supporter, use beam only with new engine ...

Curtain air bag
❈ The actual air bags in the vehicle may differ from the illustration. Curtain air bags are located along both sides of the roof rails above the front and rear doors. They are designed to help ...

Components and components location
Components Location 1. Crankcase pressure regulating valve (PRV) 2. Canister 3. Purge control solenoid valve (PCSV) 4. Fuel tank air filter 5. Catalytic converter (WCC) 6. Catalytic converter (UCC) 1. ...