Hyundai Santa Fe (TM): Repair procedures
Compression Pressure Inspection |
|
1. |
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
|
2. |
Disconnect the injector extension connector (A).
|
3. |
Remove ignition coils (A).
|
4. |
Remove spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
|
5. |
Check cylinder compression pressure.
|
6. |
Reinstall spark plugs.
|
7. |
Install ignition coils.
|
8. |
Connect the injector extension connector and ignition coil connectors.
|
9. |
Some DTC's may exist after the inspection test and may need to be manually
cleared with diagnostic tool.
|
Special service tools
Special Service Tools Tool (Number and name) Illustration Use Crankshaft front oil seal installer (09214 - L1100) (09231-H1100) Installation of the front oil seal. A : 09214 - L1100 B : 09231-H1100 Ring ...Troubleshooting
Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel Replace the crankshaft and ...See also:
Panorama Sunroof Deflector. Repair procedures
Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Loosen he mounting screws (A) located at the side of the panorama sunroof deflector. • Be careful not to damage ...
Repair procedures
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the front door trim. 2. Remove the front door window glass mounting hole ...
Outside Rear View Components and Components Location
Component Location 1. Outside rear view mirror ...