Hyundai Santa Fe (DM): Repair procedures
Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| • |
TCM replacement
|
| • |
TCM upgrading
|
TCM learning procedure
| 1. |
Automatic Transaxle Fluid (ATF) temperature: 40 ~ 100°C (104 ~
212°F)
|
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping
on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd,
3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified Throttle Position Sensor (TPS) value (15~25%).
|
Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the ...
See also:
Cowl Side Trim. Components and Components Location
Component Location 1. Cowl side trim ...
Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs. • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to ...
Components and Components Location
Components Location 1. AVN (A/V & Navigation head unit) 2. Tweeter speaker 3. External amplifier 4. Roof antenna (GPS) 5. Front door speaker 6. Rear door speaker 7. Subwoofer speaker 8. Antenna feeder ...
