Hyundai Santa Fe (DM): Repair procedures - 4WD Control System - 4 Wheel Drive (4WD) SystemHyundai Santa Fe (DM): Repair procedures

Adjustment

Description
The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the coupling.
Compensation Requirement and Procedure
1.
Simultaneous replacement of 4WD ECU (Controller) and coupling
A.
Does not require compensation.
2.
Replacement of coupling only
A.
Reset the 4WD ECU's (Controller) clutch learning.

3.
Replacement of 4WD ECU (Controller) only
A.
Before replacement: Check the ECU's clutch learning.
B.
After replacement: Enter the original ECU's clutch learning into the replacement ECU.

4WD Control System
...

4WD ECU. Components and Components Location
Components Location 1. 4WD ECU ...

See also:

Floor mat anchor(s)
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The floor mat must be properly ...

Components and Components Location
Component Location 1. Head lamp (Low) 2. Head lamp (High) 3. Position lamp 4. Turn signal lamp 5. Side marker 6. Fog lamp 7. Turn signal lamp (Door mirror) 8. Overhead console lamp 9. Room lamp 10. Cargo ...

Seat Heater Switch. Schematic Diagrams
Circuit Diagram ...