Hyundai Santa Fe (DM): Repair procedures - General Information - RestraintHyundai Santa Fe (DM): Repair procedures

Component Replacement After Deployment

Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
-
SRSCM
-
Deployed airbag(s)
-
Seat belt pretensioner(s)
-
Front impact sensors
-
SRS wiring harnesses
-
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
-
SRSCM
-
Deployed airbag(s)
-
Side impact sensor(s) for the deployed side(s)
-
SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
-
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

Description and Operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check. The lamp ...

Components and Components Location
Components 1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring 4. Passenger Airbag (PAB) 5. Side Airbag (SAB) 6. Curtain Airbag (CAB) 7. Knee Airbag (KAB) 8. Seat Belt Pretensioner (BPT) 9. Front ...

See also:

Roof Trim Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Rear Driveshaft. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...

Audio Unit. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the center air vent duct (A). 3. Seperate the audio head unit (A) from crash pad after loosening the screws (4EA). 4. Remove the audio ...