Hyundai Santa Fe (DM): Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering wheel.
|
| 3. |
Remove the steering column upper and lower shrouds
(A) after removing 3 screws.
|
| 4. |
Disconnect the light switch connector (A) and the
wiper switch connector (B).
|
| 5. |
Remove the wiper switch (A) by pushing the lock pin
(B).
|
| 6. |
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module
and Clock Spring")
|
| 7. |
Loosen the screws (2EA) from the multifunction switch
assembly (A).
|
Installation
| 1. |
Install the multifunction switch.
|
| 2. |
Install the clock spring and steering wheel.
|
| 3. |
Install the steering column upper and lower shrouds.
|
| 4. |
Install the steering wheel.
|
Inspection
| 1. |
With the multi function switch in each position,
make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch
Lighting switch (Auto light)
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
| 1. |
With the multi function switch in each position,
make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
|
Inspection (With GDS)
| 1. |
Check IPM input/output specification of multifunction
switch using the GDS. If the specification is abnormal, replace the
lamp or wiper switch.
|
| 2. |
If diagnosis is required on the multifunction switch,
select model and "IPM".
|
| 3. |
Select "Current data" and check the input/output
condition of "Multifunction switch".
|
| 4. |
To perform test on "Multifunction switch" outputs,
select "Actuation test".
|
Components and Components Location
Component ...
Horn
...
See also:
Tires and wheels
NOTICE It is permissible to add 3 psi to the standard tire pressure specification if colder temperatures are expected soon. Tires typically lose 1psi (7kPa) for every 12°F temperature drop. If extreme ...
Hazard Lamp Switch. Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of hazard lamp switch ...
Drive Plate. Repair procedures
Removal and Installation 1. Remove the automatic transaxle . 2. Remove the drive plate (A) and the adapter plate (B). Tightening torque : 117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft) • Always ...
