Hyundai Santa Fe: Repair procedures - Horn - Body Electrical SystemHyundai Santa Fe: Repair procedures

Removal

1.
Remove the front bumper cover.
2.
Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B).
[Disk type]

[Shell type]


Installation

1.
Install the horns after connecting the horn connectors.
2.
Install the front bumper cover.

Inspection

Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
1.
Remove the horn relay (A) from the engine room relay box.
2.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
3.
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.


Components and Components Location
Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn (Low pitch/Disk type) 3*. Horn (Low pitch/Shell type) 4. Horn (High pitch/Disk type) 4*. Horn (High pitch/Shell type) 5. ...

See also:

Rear Door Outside Handle. Components and Components Location
Component Location 1. Rear door outside handle ...

Battery Sensor. Repair procedures
Removal 1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the battery negative (-) cable after removing the bolts (B). Installation 1. Install in the ...

Console Armrest. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...