Hyundai Santa Fe (DM): Repair procedures
Inspection
1. |
Remove the front door trim.
|
2. |
Remove the front door module.
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and
ground according to the table. To prevent damage to the actuator, apply
battery voltage only momentarily.
|
5. |
Check for continuity between the terminals in each
switch position according to the table.
|
1. |
Remove the rear door trim.
|
2. |
Remove the rear door module.
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and
ground according to the table. To prevent damage to the actuator, apply
battery voltage only momentarily.
|
5. |
Check for continuity between the terminals in each
switch position according to the table.
|
1. |
Remove the tailgate trim.
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and
ground according to the table. To prevent damage to the actuator, apply
battery voltage only momentarily.
|
1. |
Remove the tailgate trim.
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check for continuity between the terminals in each
switch position according to the table.
|
1. |
Disconnect the connector (A) and bolts from the hood
switch.
|
2. |
Check for continuity between the terminals and ground
according to the table.
|
1. |
Remove the burglar horn after removing a bolt and
disconnect the 2P connector from the burglar horn.
|
2. |
Test the burglar horn by connecting battery power
to the terminal 1 and ground the terminal 2.
|
3. |
The burglar horn should sound. If the burglar horn
fails to sound replace it.
|
Description and Operation
Description Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, when door, hood, or Tailgate is opened, there is no alarm sound ...Transmitter. Repair procedures
Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn't flicker. Standard ...See also:
Fuel Pressure Control Valve. Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel pressure regulator ...
Auto Head Lamp Leveling
Unit. Description and Operation
Description According to driving environment and loading state of vehicle, head lamp lighting direction is changed to keep the driver's visibility range and to protect the driver's vision from ...
Radial-ply tires
Radial-ply tires provide improved tread life, road hazard resistance and smoother high speed ride. The radial- ply tires used on this vehicle are of belted construction, and are selected to complement ...